- This topic has 0 replies, 1 voice, and was last updated 2 years, 6 months ago by .
Viewing 1 post (of 1 total)
-
Posts
-
How would you go about replicating this handle? I’m having trouble trying to CNC a part and utilize a jig for round over.
I’m not sure if this is the right place, but I am struggling with modeling up this handle. I’m looking to make them for my kitchen cabinets. My plan is to CNC out what I can and finish the rest on the router table with a round over bit. Any suggestions? I’ve tried tracing the angles I can get to onto paper and tracing them out in Fusion 360, but i just can’t figure this one out.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.